Home Page for the TeradataForum
 
https:

Archives of the TeradataForum

Message Posted: Sun, 15 Apr 2013 @ 02:04:29 GMT


     
  <Prev Next>   <<First <Prev Next> Last>>  


Subj:   Re: VM Hangs when Viewpoint services enabled
 
From:   Mutsch, Joerg

It could be a RAM issue since 1 GB is not really enough for the image. And it does not mean that your image hang; I would say that it is most likely swapping the content (check the state of your disk and if it is busy) which leads to a tremendous performance decrease.

For the TD 14 express with 40 GB it's recommend to apply at least 2.5 GB of RAM. I think the same amount of RAM would be applicable to the 13.10 Image However if you have only about 4 GB Ram available you might also end up in swapping the content of the Image. Make sure that your CPU is able to handle 64bit OS (see the link below) but I think this might be no issue otherwise the image would not even start.

RAM is not really expensive anymore and I personally have 16 GB in my notebook just to make sure that I can run at least 2 or 3 images at the same time without having the images swapping around.

See also here for additional information:

developer.teradata.com/....


Thanks

Joerg



     
  <Prev Next>   <<First <Prev Next> Last>>  
 
 
 
 
 
 
 
 
  
  Top Home Privacy Feedback  
 
 
Copyright for the TeradataForum (TDATA-L), Manta BlueSky    
Copyright 2016 - All Rights Reserved    
Last Modified: 24 Jul 2020