Archives of the TeradataForum
Message Posted: Tue, 23 Mar 2004 @ 19:41:26 GMT
I would like to capture the error message when an exception occurs in a stored procedure. When handling exceptions, the codes are contained in :SQLCODE and :SQLSTATE. From previous posts on the forum, I discovered the message for :SQLCODE can be found in table DBC.ERRORMSGS. However, the messages on this table often contain parameters. For instance, the following is an example message from DBC.ERRORMSGS:
'Column %FSTR not found in %VSTR.'
Does a good way exist to identify the dynamic message at run time - in other words, for the example above, identify %FSTR and %VSTR?
Thanks for any assistance,
|Copyright 2016 - All Rights Reserved|
|Last Modified: 28 Jun 2020|