Archives of the TeradataForum

Message Posted: Thu, 03 Feb 2011 @ 10:28:12 GMT

	<Prev	Next>		<<First	<Prev	Next>	Last>>

Hello,

any idea why would a release MLOAD command take 3 hours and then result into: Mload not active?

     ,release mload DBname.TBname;
     , *** Failure 2580 MLoad not active on table TBname.
     ,                Statement# 1, Info =0
     , *** Total elapsed time was 3 hours, 0 minutes and 23 seconds.

Actually, I can confirm that at the time of this release MLOAD command, the Multiload job was already finished successfully.

Thanks in advance for any suggestions, I don't get it.

Tomas Gorner

	<Prev	Next>		<<First	<Prev	Next>	Last>>